Nokia 108 LCD Light Solution
Problems that may often be found on Nokia phones like 1280 1202 C1-01 DLL, nokia new model how to install it using Solder Lcd / not using the LCD connector, such as the Nokia 108 mobile phone is the problem break point display and Light.
It is very often yes, if this phone runs out of water in the area affected by the LCD must menggalami break point, chances are it is because the phone is not directly exposed to water depleted in the dry / mobile phone battery is not off so that the water flows through the lcd collided so lines lcd the phone is broken.
Make your mobile phone owners cadul we have a suggestion for you, in order to remove the battery and dry the phone directly affected by the water so as not to experience a break point on the path lcd / other woods, not only lcd path that will be damaged, but other components are also damaged due to the current who compete through the water.
For solutions on mobile nokia 108 Lcd break point, you have to do work that is not familiar, namely, do the jumper on the track that dropped 108 phone Lcd, to how you can use the following schema to be clear, you can use a means other than a direct jumper to the resistor, you can also use the bottom of the foot jumper to lcd, how, Kerik lines visible under foot the LCD using the crankcase, then solder the track and do jumnper.
But if you are lazy Kerik LCD lines, in because the lines were dropped Lcd Only 2/1, you can directly lcd jumper to resistor as shown in the example schema above, before you do the jumper, you first check the LCD foot flows which are not out, using a multi-tester checks, when it’s positive parts of your new breaking jumper.