Samsung Galaxy Note 5 N920 Insert Sim Solution Jumper Problem Ways
Samsung Galaxy Note 5 N920 Insert Sim IC Solution Jumper Problem Ways
In case of sim sim problem in Samsung Galaxy Note 5 N920 will be shown insert sim, yes invalid, and can not show signal.to solve Samsung Galaxy Note 5 N920 Insert Yes Solution IC Bridge Problem Ways we have to do a few simple steps How To give it in this first step of post.in replace your sim and try it.scratch SIM points on the mobile slightly then try.
After this assembly, check all the sim jack points on the motherboard with meter.check all these parts and track that are given in the diagram above and if any of them lack jumpers to make the route in good condition. If any components are missing Replace them with new ones.
You can also change the simic and you can apply jumpers after removing ic from the motherboard. There are some posts also to describe how to make jumpers in simic to solve the problem insertion sim.
For more information and new tips and tricks on this troubleshooting continue visiting this page, we will update if there will be new updates. Some related messages are also given below you can read more about the mobile phone.
Please note that although each diagram and solution posted on our website has been tested by one or more members of our team prior to publication, we will not be liable for any loss or damage, including personal injury. .
Before you replace or repair the sim card connector sim card make sure the connector is really problematic and in fact you should replace or repair, please carefully the sim card connector iPhone from The note 5 N920 of Samsung Galaxy, Can be repaired, can not be repaired please replace the new SIM card connector, do the replacement of the Samsung Galaxy Note 5 N920 SIM card well, can only be removed with a single blower, And insert the SIM card can only be done With solder, because If you use the blower can not, why not? Because under the SIM card connector PCB too much capacitor or ic resistor, which is more likely to fall if they are forced to put the SIM card connector through a blower under the PCB, by inserting the card SIM by the direction of the blower From The top or side of the SIM card connector would be useless, after the termination of the plug connector SIM jack also breaks, so the only way is to install the connector The SIM card through welding.
Check the voltage on the line as shown above and make sure that everything produces voltage.
If there is a line does not produce voltage then you have to make a bridge as shown above.
If the four lines have produced a voltage, try inserting the SIM card and turning on the cell phone.