Nokia 1800 charger not supported problem solution ways jumpers

Posted in Nokia 1800 with Charging, Charging Jumpers, Charging Problem, Charging Solution, Charging Ways, Nokia on February 7, 2011

Charger not supported occurs when the temperature of the battery resistance is damaged, this solution gives the exact location of the said chip-resistor on the main circuit board. This chip-resistor should be replaced when a charger is not supported on the LCD display when in a plug-in charger.


The value of the said chip resistor is 47K, you can find a replacement to any broken old Nokia PCB.
if we plug in the charger and it shows the Nokia 1800 charger not supported error in this case especially the loading pin works fine, the guilt of two important things on his charger is your first step to change the charger when not charging ok.some working time may be the reason for janiuan charger charger charger janiun problem.if supported it may be that you 47k this resistance is defined in schedules attached to this post.so remove this resistor and a new one to replace Nokia on board for change.

for more detail and new tips and tricks about this problem keep visiting this page we will update it timely with new diagrams.some related post are also given bellow you can read them also for more information.

to get new repairing diagrams and applications with email “Enter your email address for RSS:” at the right side at top and press “subscribe”

Share and Enjoy

•