Mito T720 Not Charging Solutions
How often do you get a problem like this? Is it very frequently, if you are here in our place very often get mito Client Tablet T720 not charging, because here quite a lot of people who use this China phone Android tablet, and so are complaints that in dapati is on its charging connectors are problematic.
For those of you who have dropped out permasalaha on T720 phone lines you can see the path Charging Charging full below, in addition we provide the charging path mito Schema T720, we will also discuss how to install this T720 mito Charging connector.
For those of you who have never replace the connector mito Tablet T720 is a good idea to read / follow the way which will be reported through this article, it is important for those of you who just want the first time to replace the T720 charging connector.
The first, please open all the bolts are there in the mobile spine, then open the spine of the phone, then you loose also 2 two existing bolts on the bottom and loose Buzzer also 2 two existing screws in the PCB layout Charging connector, after you 4 finished removing the four screws on the bottom at the Buzzer Charging connector and the PCB.
Further down you loose the buzzer & Flexyble connector between the engine PCB and PCB connectors Charging plus Mic & vibrator, which flexyble loose solder on the PCB in any Charging connector, use solder off, being careful not to damage his flexyble, then you loose the charging PCB of the place.
After all the stages of the release bolt flexyble & PCB connector charging is finished, now its the time you step up to the release of Charging connector, please unplug the T720 mobile phone charging using a blower, try to remove it from the charging connector under the PCB, focus / point your eyes blower Charging to the location of the connector, if tin is ripe, you just lift chargingnya connector using tweezers.
Prepare a new charging connector, please give advance tin legs chargingnya connector so you can install it easily, and advanced to the stage of installing charging connector, charging connector put it right in the PCB layout konetor charging, then you plug the blower from the bottom of the PCB using do not forget the focus point to the charging connector, after the tin is ripe, you just slide the slide point to the right position on the footprints of the existing connector on the PCB.
If the existing foot charging connector on the PCB damaged / broken, you can make jumpers as Schema we provide above, may in this way be able to cope with the problems mito T720 Charging on the phone, good luck, if you have not managed to learn and please keep on the look solution which we write here.